Halco 10305 LWA-D23U2-50 LINEAR WRAPAROUND; DIFFUSED LENS; 23W; 120-277V; 2FT; 5000K
Notes:
- Dimmable 120V lamps should only be used on 120V circuits. Lamps are designed for use with an analog dimmer and these products may not be compatible with all dimming devices. Lamps should be tested in the application prior to full installations on circuits using such devices. Not for use on timing devices; photosensors;digital dimmers or occupancy sensors. Ensure minimum dimmer load is met for best performance.
- Caution: Risk of electric shock. Never disassemble or modify the bulb; no user serviceable parts inside.To avoid burns; do not touch the bulb during operation and allow to cool completely after switching off. This device is not intended for use in emergency exit fixtures. This device complies with Part 18 of the FCC rules. This product may cause interference with other devices. If interference occurs; change the location of the products involved.
- Do not use where directly exposed to water.
- Do not use in totally enclosed fixtures or IC or ICAT rated recessed cans.
- Dimmable lamps dim down to 5%; but are limited by the dimming device range.
Warnings:
- Use only on 120 volts; 60-hertz frequency
- Risk of electric shock
- Do not use where directly exposed to water
- Never disassemble or modify the bulb
- Do not use in totally enclosed fixtures
- This device is not intended for use with emergency exit fixtures
- If this product causes interference with other devices; change the location of the products involved
- Dimmable 120V lamps should be used only on 120V circuits. Lamps are designed for use with analog dimmer and these products may not be compatible with all dimming devices. Lamps should be tested in the application prior to full installations on circuits using such devices. Not for use on timing devices; photo-sensors; digital dimmers or occupancy sensors. Ensure minimum dimmer load is met for best performance
- Dimmable lamps dim down to 5%; but are limited by the dimming device range
- This device is intended for use on Class 2 circuits only
